Argghhh !!! New Turnigy 6s 2650

[Twister3D]

Damn I have received my new 6s Batteries & they have used 10AWG wire which do not fit my EC3's.
I have an old Turnigy 6s and a Hyperion 6s and they both fit my EC3 connectors fine.
Looks like I will have to change to EC5's, damn more soldering and whats the best way to take off the old connecters without having to cut the wire?

[sacko]

They pop out.

Put the opposite bullet on the connector and push it out.

[Si_B]

Or just run a blade down the side and break them open. Only do one at a time though !!!

[johnsandywhite]

Or just run a blade down the side and break them open. Only do one at a time though !!!

That's what I did with my Zippy's. EC5's are BETTER anyway. Although I still have an EC3 on one of my 600E's plus several adaptors from EC3 to EC5 and visa versa.

[Twister3D]

Or just run a blade down the side and break them open. Only do one at a time though !!!

Yes thanks Si, could be an expensive mistake

[Si_B]

Trust me, you will only do it once !!!

[cjcj1949]

You can stick with ec3s if you want. Just solder in a thinner piece of wire. I doubt if you will notice the difference in performance.

[vinny155]

can you file down the tinned section of wire until it comfortably fits in the ec3 and then solder it