PL6 to Quantum balance board connection

[That Guy]

Just got a PL6 and purchased a couple of Quantum balance boards, EC5 and another for the 130x. Just discovered the balance lead coming from the boards are not compatible with the PL6 It would be very much appreciated if someone could point me in the direction of an adapter cable to go from the Quantum board to the PL6.

Thanks

[Raving Jim]

ProgressiveRC - FMA PL8/PL6 Adapter Cable for Parallel Charge Board

[That Guy]

Thank you Jim for the link, are the cables available in the UK anywhere?

[Raving Jim]

Not seen them over here myself , all my friends have ordered from here an only been a couple of days for arrival

[That Guy]

Will get one ordered now. Thanks again Jim for the quick reply

[kroozing]

Or use this if you want the uk
Revolectrix Cell Pro PowerLab PL8/PL6 Adapter Board JST-XH PL8GPKOSTD

I use this for a non revolextric parallel board.

[That Guy]

I have just place an order with Progressive for the cable, thanks anyway

[jimmyhorns]

ah, only just seen this...

you can get the bits to make your own lead from RS components

[That Guy]

Was less than £6 posted and I don't have to get the soldiering iron out

[Wardy1982]

With this adaptor board does E pl6 still need the wiring mode changing from fma to xh?

[Raving Jim]

Yes xh wiring mode is used for the parellel boards .

[Wardy1982]

Thanks Jim. Just got an efuel 1200w psu and a pl6 so looking at all connections now. Whats the best connection type to connect pl6 to the efuel.

[Raving Jim]

Either put 4 mm bullet connectors and plug straight into you efuel supply or if your putting into a box you can buy some 4mm posts that will bolt down to your box .