PL8 will not charge over 76%????

[Summa1988]

yes...im back again with another PL8 problem

for some reason the PL chargers as normal until around 70-75% then nothing happens, it just sits there.

ive now tried 6 different batts (TP's and Opti's), each one at a time and none of them are getting fully charged????

im charging in the house so its not cold weather, ive checked its set to 4.20v full. and ive tried generic, fast charge and high power.

[Mark_T]

What is is showing as the charge current once it hits 70-75% and what is showing on the bypass screen?

[Summa1988]

its been the MPA board, on the first charge it wasnt pushed all the way into the balance port, so the 6cell of every pack was lagging, so my pl8 kept going into safe mode only allowing 500ma to balance the packs out.

[Mark_T]

Glad you found it, that is where I was heading. You can usually tell what is going on with the PL8 by checking a few of the information screens to help you figure out the problem ...