Tweet
PL6 wont remember max charge power , WTF?
My batteries, Revolectrix Platinum, are good for 6C charging, but I am conservative type and will settle for 2C if I'm in hurry, and 1C otherwise.
If I attach all 6 to MPA (and set to parallel charging 6P), I have power choices A1C A2C A3C (these are not actual 2C or 3C; I do not know what these are) and then from 100mA up to 1.66A ; if I attach fewer it's max 2A per battery. Either way, its not even 1C. Since my batteries are 2.2Ah I want up to have 5A, per battery (I would probably scale down to 4A per battery when charging all 6). PSU Robbe 30V 1000W , which should be sufficient. I can configure my charger via USB to allow max charging 5A, but it seems to promptly forget this setting after I set it, turn if off and move PL6 to my charging point. Any hints what I might be doing wrong?
If I attach all 6 to MPA (and set to parallel charging 6P), I have power choices A1C A2C A3C (these are not actual 2C or 3C; I do not know what these are) and then from 100mA up to 1.66A ; if I attach fewer it's max 2A per battery. Either way, its not even 1C. Since my batteries are 2.2Ah I want up to have 5A, per battery (I would probably scale down to 4A per battery when charging all 6). PSU Robbe 30V 1000W , which should be sufficient. I can configure my charger via USB to allow max charging 5A, but it seems to promptly forget this setting after I set it, turn if off and move PL6 to my charging point. Any hints what I might be doing wrong?
Comment