Not getting full charge Optipower 6s 5000

[Gazzer1uk]

I think I was v 1.1, is there a website with the latest firmware, I can go see if there is new release plus how to connect it to the laptop etc!

cheers,

Gaz

[coolice]

I think I was v 1.1, is there a website with the latest firmware, I can go see if there is new release plus how to connect it to the laptop etc!

cheers,

Gaz

*EDIT* Seems like this might not be for your one, but the older Emperor.

Might just need top try a reset. Below is for the older Emperor.

Here you go buddy;

http://www.logicrc.com/firmware/Readme.pdf

Seems it's now on V2, there is also instructions on how to go through the update procedure.
.

[Gazzer1uk]

You know I may have mentioned this could be user error........

Well to check things out further, I charged up my 2s 220mah battery..... had to go through and reset everything. Started charging, finished after 6 minutes with only 200mah added.... as this is connected to an Align switch with glow and led indications, no surprise when turned on, to see only to LED's lit......

I used my old charger and voila was all ok......

Must be the charger, but I am sure it is all good.....

RTFM again..... oh, ah, hum, embarrassing possibly?

On the main screen, I have been scrolling down to store mode start. Yep you guessed it, lost in translation, been using that mode....

SO I am now going to humbly try the CHG mode and see what happens.......

I am likely to be very embarrassed I feel....., I'll let you know in a bit....

Gaz

[Gazzer1uk]

I am so embarrassed.....

This was indeed the issue, battery reading at 98%, cells are just below 4.2 volts, but I cut it off slightly early.... What a txxt...... sorry for wasting time guys.....

If I may though, the default TCS setting is 120%, is that correct, should it not be 100%?

Cheers!!

Gaz