If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I ran my Goblin 700 down as low as 12s 3300s Turnigys no probs,i run my TT E700 on packs as low as 12s 3000 and can get 4mins of 3D,lovely light setup.
If those are the same as the ones I have, they say 30C with 80C burst. Assuming those ratings are for real it means you've got 129 amps continuous and an insane amount of amps burst, well in excess of the 160 of the YGE.
On my setups these packs don't even break a sweat. As I've been lowering my headspeeds for longer flight times I'm only drawing about 30-40 amps average and very brief peaks of between 95 and 130 amps. This is on a Rave Ballistic and Minicopter Triabolo, Kosmik 160 and smaller motors than yours but it's all a matter of how hard you push it.
Anyway those packs should do very well unless you really hammer them extremely hard.
Kasama, Minicopter, Henseleit, JR, Shape, Beam
Robbe, RMJ Raptor gasser, powered by
Spartan, Spirit, BeastX, Kontronik, CY Total-G, DX8
member of Epsom Downs and Bloobird clubs
Proud recipient of 7 EGS! and a platinum star
Run these exact packs in my Gobby 700 & 500. Depending on head speed I get around 5 min flight times on my 700 but I do have an HPS head and govern the head down to around 1900 in idle 1, it flys beautiful sport and non adventurous 3d with this setup and if I do want to get a bit more up on it as they say, then idle 2 is setup to the max and flight times are down to 4 mins with 20% left at the end.
Sean,
Logo 700 Xxtreme
SAB Gobbler 700
SAB Gobby 500
T-Rex 700, Now FuBarred (Lol)
T-Rex 700E, 12s Fun
T-Rex 250 FBL, Less parts to break,
DJi 450 FPV Flamewheel
Comment