If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I went for all DS480s in the end, I just need to decide upon the rx now, AR6200 (too big but reliable?), AR6250 (reception issues?), AR6100E or AR6110E..?
Unfortunately the DS480s mounting holes are slightly narrower than the pre-drilled holes in the CF, is it OK to slot the holes in the servos? Should I locktite the mounting surfaces together to give a bit more rigidity?
Tweet
Comment