new titan

[new be]

just got mini titan had one hover so far wind is 2 strong any tips for pos week parts and upgrades

[funfreex]

Well done on your first hover.
Not really any weak parts to watch out for unless it hits the ground hard. Stock up on plenty of main shafts, feathering spindles and blades and perhaps a main drive gear (nylon). If you bend a main shaft properly you may find the plastic hub will be damaged also, around where the jesus bolt goes through. Other than that it just depends how hard it goes in.
Good luck with the new addition.

jamie

[new be]

thanks the main sharft was bent in the kit so she had i bit of a shake have got a new one from shop. i did a part ex with my t rex 450 for the titan i like the titan much better

[cambs flyer]

Congrat NB, you've got yourself a serious piece of kit there mate.

Keep an eye on those tree tops as even the 400 class have limits where the wind is concerened.

Stick with Jamies advise bro, and your do just fine, and believe me it only gets better from this point onwards.

[h3li]

Congratulations on your purchase AND first hover... from this corner too!

I would also mention, you might want to buy a set (or 2) of mixing levers (Part number: PV0712). As these can break often when your blades strike the ground - ie: a tip-over or coming down in long grass (this is from experience!!)

All the best with your Heli - the Mini Titan really is great!

[new be]

thanks all just put new sharft on and balanced the blades witch was out miles so i hope the woble has gon just need the wind 2 drop off now cant wait to get out with her