Another fusion ball link failure or Beast X problem?

[waveydavey]

i never said align links matey, align servo horns.

cheers

My bad, I blame the egg nog

[waveydavey]

Did you not also have the servos glitching as you spooled up too Andy

[LipolyGone]

it is disappointing to me that if any outrage fails now it is instantly the helis fault but oh wells, that is just they way it is ATM and something outrage need to address somehow.

I cant be sure what happened only that 3 short hops found me a very stable model helicopter that just sat in the hover with no problem then wham
over it went & straight into the floor. It might have been the link it might have been the beast x all I know is I now dont trust either & will be flying my align helis with flybars
from now on. I have had it with trying flybarless on the cheep it just doesnt work for me without vbar.

[raptorheli2]

Martin, the problem with FBL is it adds a level of complication when these things happen. it could have been too many things so just rebuild it and double check everything-it will be fine again.

if you doubt the links then change them all, very understandable and cheap peace of mind. check your RX carefully, re-flash the beastx, change the servo horns and get her flying again.

cheers

[anjki]

Did you not also have the servos glitching as you spooled up too Andy

At the club,we changed to a more sensitive black sensor for testing.This did show up with glitching servos so it was not flown.Its first flight at home, was with my blue sensor and no servo glitching,but it picked up on the vibe when pitch was increased.
I feel for ya Mark,its a nasty thing to happen with no real answer.I am sure with further investigation a vibe will be found,but do check first without blades.As Dave said,the glitching servos are a good indication and also can be seen when spooled up without blades.