upgrade

[biker]

hi all
bought the upgrade for brushless motor was ok for a couple of flights then went ape any one else had probs.
ta roger

[kylelnsn]

hi all
bought the upgrade for brushless motor was ok for a couple of flights then went ape any one else had probs.
ta roger

Is the genuine Blade upgrade?

What are the symptoms?

[biker]

hi
yes its the original upgrade spools up ok hovers for less tha 30 secs spins out control ???

[SaneAdam]

That is odd…. intermittent connection somewhere perhaps? Something not quite seated properly? Although, you would think it would either work or not work if that were the case?

Is the tail behaving normal otherwise up until that point?

[biker]

hi again
yesi think i have traced it back to a intermit ant oath lead need to put multimeter on thanks for the input will let you know the result thanks again
roger

[Euclid]

Mine would cut out for no reason (that I could find). Removed it after just a few batteries.

[SaneAdam]

I have been using it since the upgrade motor came out without any kind of problems. Solid and very reliable. Wonder if there a few faulty units out there

[biker]

hi
many thanks for reply i am not sure but i will check all leads for continuity i have checked main board and have replaced the old motor and so it works fine with that ??? i will post any update asap love nano lol i hope to see you at horbury in the near future going up to join this weekend .
regards roger

[biker]

hi again
i think it could be this little fella tried in another nano on a 1 s 3.7 150 mh left the 300 mh out seems to work ok will give it blast around the garden and report back


yes all fine now 2 lipos and working fine tnks for input
roger