Swashplate doesn't level when release stick

[Serial]

Hi guys im ste if anyone can help me that will be mint, i have a blade mcpx with dx6i , the problem i have is the right hand stick (mode 2) , when i use it the swash place stays in the same position as i pressed last even when i release this stick to centre it, i dont know if thats what it should do or ?, i have cleaned the board and servo contacts .
This problem just makes it hard work as i am new to 3d so and only just learned to flip it so when i flip the swash plate stays in direction i flip it so it flies away to far and fast and as i havent got my head around controls in inverted i cant readjust fast enough, thanks guys

[Serial]

Anybody?

[parksy]

Hey Serial, strange one? Does it do this on the ground,ie does swash plate act normally before take off and before spinning blades? It should return to level when you release stick. If you pop servo links off does swash move freely? May need oiling to free it up. While they are off check servos are moving up/centre/down with stick input. Check through transmitter settings, you may have switched something. Check trims etc. If it has flown fine before have you changed anything or crashed recently?

[Pav]

When you do a preflight does it level out ok without the rotors spinning?

[tomatwalden]

Hi guys im ste if anyone can help me that will be mint, i have a blade mcpx with dx6i , the problem i have is the right hand stick (mode 2) , when i use it the swash place stays in the same position as i pressed last even when i release this stick to centre it, i dont know if thats what it should do or ?, i have cleaned the board and servo contacts .
This problem just makes it hard work as i am new to 3d so and only just learned to flip it so when i flip the swash plate stays in direction i flip it so it flies away to far and fast and as i havent got my head around controls in inverted i cant readjust fast enough, thanks guys

How do you know the swashplate stays in the same place!? When flying, I can't see the swashplate movement!?

Do you mean - when you give a cyclic input (eg. go forward), the helicopter continues going forward even when you move the stick back to centre? And that to stop it, you would actively have to give it a backward instruction just to stop the forward momentum?

Or do you mean that on the bench, with throttle hold enabled, the swash stays leaning over?

[Varelco]

Sounds servo related, like its sticking maybe. When you pump on the collective does it pull it to one side?