CX2 Servo Chatter

[Duneflyer]

I recently replaced the lower rotor head and now swash plate for an aluminium ste on my CX2, as well as installing a heat sink. These additions sure make a difference - noise is down, although I am not convinced yet of the heatsink...

One thing that I notice / hear now is what seems to be "chatter" - which I think is from the servos. Can this be and how could this occur and how do I remedy it?

Any comments would be appreciated!

For other newbys out there who have a CX2 - buy a couple of spare upper and lower blade stes, as well as fly bars - you will need them :-)

[matt27]

if its from the servos i assume its probably the teeth have been striped

[Duneflyer]

Yeah, that is what I thought too but I havent crashed / damaged the servos in any manner. But I will defs have a look in closer detail if this is so.

Thanks!

[swampy]

For other newbys out there who have a CX2 - buy a couple of spare upper and lower blade stes, as well as fly bars - you will need them :-)

,,or the Extreme blades and grips, they swing back on a strike, must have saved at least 10 pairs of upper and lower blades in my 6'x7' kitchen

(newby CX2 destroyer )

[beerdeor]

genrally servo chatter is cuased by the servo binding i would check your new swash ect for tight spots any pressure on the servo at centre will make it chatter
Hope this helps jim