Announcement

Collapse
No announcement yet.

DEVO 10 settings for Blade 450X

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    DEVO 10 settings for Blade 450X

    I have converted the settings from the manual for a Dx7 to my Devo 10 radio, except I am not sure about how to do the pitch curves. I can't find the pitch curve menu anywhere. also there are AIL_CYC and ELE_CYC DR&EXPO settings that I have on my VWINRC450 FBL heli that I am not sure If I should use on the BeastX on the 450X. I have been looking into this for a couple hours now and from what I've gathered those AIL_CYC DR&EXP settings are only there for the ZYX FBL controller, which needs transmitter mixing, and the BeastX does the mixing mechanically? is this right?
    Does anyone have a DEVO 10? I have the dev seftware upgrade 3.0 also in case that matters
    Tags: None
  • #2
    oh man, I just found the page that says advanced mixer gui or standard ! I had copied the VWINRC450 FBL heli which uses the ZYX flybarless controlller to make the Blade 450X settings and it had the advanced mixer gui, which has the electronic mixing, I switched it over to standard mixer gui and there it is. everything I was looking for, 1 servo swash, travel adjusts, throttle curves, pitch curves (both had 8 points which is a bit overkill) switch assignments.

    I guess I found my own solution, but at least its here if anyone else has the same issue or if anyone has any more knowledge to add. (I'm a heli noob)

    Comment

    • #3
      DEVO 10 settings for Blade 450X

      I'm curious... How are you going to bind a 450x to a devo radio?.
      Tom
      sigpic Synergy E7SE - Kontronic Helijive 120+ ESC, vBar Neo
      SAB Goblin 630 Competition       - Castle Edge 120HV, vBar Neo
      Blade 700X - Castle Edge 160HV ESC, Mini vBar
      Logo 550SXv2 - Castle 130LV ESC, vBar Neo
      .... and a Gaui X3
      Spektrum DX8 ; Mikado VBC ; RealFlight 7 & neXt sims       ... and two EGS'



      Comment

      • #4
        Originally posted by tomatwalden View Post
        I'm curious... How are you going to bind a 450x to a devo radio?.
        With Devo txs you can update the software from "deviationtx dot com" it gives you a better interface with more options, one of them being protocol. I can choose to use DSM2, DSMX, any Devo or walkera rxs and a few more without physically modding the DEVO 10.
        And if I want to use turnigy (example 9x) rx or flysky, frsky, Hubsan or skyartek rxs there is a small physical mod, but switchable between them all depending on which of the 30 stored models I use(and setup).
        This is the reason I bought the radio. It's been great so far an I can use all the rx I have gathered over the years

        Comment

        Previous template Next
        Working...
        X