Tweet
Stock gyro sensitivity
Hi,after fitting a hs5065 to the tail,do i need to alter the stock gyro sensitivity on the gyro(screw)?
Where is best setting?
Where is best setting?
-
T- rex 600n V-bar
Logo 550sx V-bar
Logo 600sx V-bar
Logo 600sx V-bar night flyer
VBControl, but not the gay white version as i'm simply not gay enough to pull it off! -
no, but you might need to change the gain on your gyro menu on your dx6i/dx7.Mike
www.RC-Scotland.com
T-Rex 700G G270 DS610s GP750/DS650
TZ Frenzy .53 Red Line
T-Rex 600 .52 ASP
T-Rex 600 .80 ASP 4ST -
Nice one
...i would say its around half way,is this correct?or does it not matter?
T- rex 600n V-bar
Logo 550sx V-bar
Logo 600sx V-bar
Logo 600sx V-bar night flyer
VBControl, but not the gay white version as i'm simply not gay enough to pull it off!Comment
-
Stock gyro? Set the DS switch on the side of the gyro to DS position. The gain is set through the TX, remote gain control, depends on what TX/RX you are using. DX6i there are two setting in the Gyro menu, position 0 set to 65 and position 1 set to 30, this gives you rate mode in position 1 (down) and HH in position 0 (up), do your tail setup for no drift with no trim or subtrim, in RATE mode but adjusting the control rod length to achive no drift. Now go to HH mode, position 0 (up) and increase the gain in the TX untill the tail wags then back it off 5%.Comment
Comment