little help needed

[jonnyg]

hi guys, just a quick one , im having to put 8 clicks forward trim to get an even hover, ive centred the swash, checked the cg but will only stop pulling back with 8 clicks forward, any ideas guys?
thanks jon

[machasm]

Lengthen or shorten the link to the elevator servo and remove the trim.
It may look level but obviously isn't.

[Boggy]

is the elevator servo centered? sounds like its not.

flick the throttle hold switch forward. set the left stick to the center position. check the servo push pull arm is at a right angle to the servo( im guessing the top will be slightly back)if its ok check the elev' arm coming from the front of the frame is it level? if these are both ok shorten the link from that arm to the swash by one turn and try it.

here is a picture of mine at center stick

[163phil]

...and if you're still having problems after all that then check your flybar paddle arms

[jonnyg]

cheers fellas, done all the above, and seems to be just fine now if not a bit more stable than before thanks again
jon

[machasm]

Result.