Need help setting 300x up

[A.N.T]

The tail frequency choices are 50/165/270*/333/560hz stock is 270 with the align servo installed I set it at 165hz

The servo is still working fine it responds to all inputs while stationary no problem, adjusting the gain on the tx is working as the lights on the beast x scroll as your adjusting it, the stock gain is 77% with the DX6i and with the heli initialized if you turn the heli 45 degrees it reaches its end point in both directions.

I haven't had the heli in the air since changing the tail servo, when it had the ds76t on it after the original crash it was a little wobbly but that was down to blade tracking and head setup it wasn't all fully dialled in it was just a test flight, then I burnt out the tail servo and fitted first of all a ds76 cyclic and thats when all the problems started it started to wag 7 or so inches left to right then it got to the point where it went to a full pirouette if I compensate on the rudder it doesn't really react until I give it a full input then it spins in the other direction (this is all being done while its on the ground)


I ve made further adjustments over the last couple of days but the weather has been so s**t I've not tested them

my beast x settings:
setup menu

A: default blue
B: default blue
C: default blue
D: 165hz red flashing
E: endpoints set back off from full throw with no binding
F: default blue (reversed)
G: servo arms set at 90 degrees and swash levelled
H: Default red solid
I : default purple (nor nor rev)
J: set with 10 degrees +- ( blade cyclic pitch geometry)
K: still needs adjusting
L: set to their limits and then backed off with no binding
M: default blue
N: default blue

[A.N.T]

Looks like issue has been resolved

Just waiting for tx batteries to charge and then its outside we go for test flight.

looks like the align servo runs in normal mode instead of the stock being reversed, which I thought I had already tried once but obviously hadn't, got the gyro gain set at 62% atm, will see if this needs adjustment and running at 333hz as per beastx website.

[kevcov30]

Went through the exact same problem recently after my tail servo burnt out. Bought an align servo and set it up and had a fast wag with book gain set. Lowering gain just slowed the wag speed. Tried everything to eliminate vibration and tried checked settings many times but stayed the same. Had to send it back in the end but all that was changed was the servo frequency to 50hz and belt tension tightened ( much tighter than book setup). No more wag but gain needed lowering about 5. Had refitted a stock servo before sending it back. Worth noting that the align servos I have tried needed the tail sensor direction on the gyro reversing from book setting and the rudder reverse setting reversing from the book setting on the tx. I ended up fitting an align ds525m tail servo and setting the gain to 72 and the freq to 333hz. Now fly's a dream with no wag whatsoever. Message me if you want the full story lol as I also believe the new metal tail grips I fitted at the same time as the servo caused some of the problem, tried them on my dads and his started wagging too until removed again.

[Moron]

With the problem with your 130X and the swash tilt problem. I had the same problem and sent it back to H/H who also told me they check it out and it was all fine Someone on this forum told me to select the model for the 130X on my transmitter and reset the transmitter to the factory setting and re set the 130X settings on your transmitter and all was fine the swash tilt reset itself and had no problem with it since.It was the transmitter not the 130X

[tomatwalden]

Very old thread guys - over a year ago from the orig post.