Am I just being stupid or............

[A.N.T]

So I decided to finally fix and get my 300x flying again today plugged all the servos, batteryand esc into the 7200bx and............ nothing absolute silence no lights on the bx nothing.

I have the motor, esc wire in the throttle channel so this should be powering up the bx unit shouldn't it?

I'm not just being stupid am I?

I hope its not bloody faulty as I only has just got it back from having a dodgy setup button.........


Not having much luck today, Found that my new 130x suffers from power up tilt where the aileron servo drops as the throttle is increased, once in the air its fine apart from a very slow anticlockwise rotation guess thats just the rudder gain but the aileron tilt is the faulty 3in1.


Next up we have the Nano, started to experience brown outs mid flight, would just drop out of the sky, was intermittent at first but now it wont even bind, just get the blue flashing led




Getting bloody annoyed with HH blade products, they seem to be forever breaking or not working properly out of the box..

[Bob H]

Servo connectors the right way round on the 7200bx? Just my initial thought if the servos aren't doing anything as well. After that make sure there is voltage coming out of the ESC on the + & gnd lines on the throttle lead.

[A.N.T]

Yes I was being stupid had the throttle lead wrong way round, had tried it other way round earlier but obviously wasn't a good enough connection.

Drama over, just the nano and 130x to sort out now, that ll have to wait until I get back from Dam.