Anyone parallel charging there 2s on a cellpro 10s or similar?

[simon1]

Im just looking into getting sorted with para charging my 130x lipos, I have a mixture of overlander with jst discharge connectors and eflight connectors. So will standardise the connectors once i sort which charge lead i need.

As in title what leads do people use with there cellpro's ? to charge up to 6 of ther lipos in parallel? Would i need a different charge board and what lead will be ok with the cellpro 10s?

Thanks in advance

[Gamdons]

i charge my mcpx using a 6 lead parallel connected into the balance board that plugs into my cellpro 10s

[ianmat]

I bought 5 overlander 450mAh batteries for my 130x, but the all came with the correct eflight connectors. To charge them I bought a 6 way parallel charging cable from electriflier, which comes with the correct eflight connectors. My Ansmann Xmove2 charger has just enough power to charge all 5 at 1C charge rate. I don't really use the eflight battery that came with the 130x because you shouldn't really charge different capacity batteries in parallel, you run the risk of overcharging the lower capacity battery.
Using the above setup and charging at 4A total my 5 batteries are charged in about 35 minutes!!!

[st200ol]

ianmat, you have your series and parallel charging a bit mixed up.

In parallel charge configuration it is possible to charge any combination of battery capacities, they must be the same voltage, eg all 2S or all 3S etc.

[Gymbal]

Parallel charging my stock batteries with the parallel harness from rc-hero on a turnigy accucell... Works flawlessley at 1c. Not tried it higher.

[tomatwalden]

I'm using this with the stock battery connectors : Parallel (x6) JST-PH (130X) Charge Lead « ElectriFlyer

T

[simon1]

are the two above posts charging with a cellpro 10s?