Tweet
I can't seem to access the Gyro on my 130X
I have an issue where the tail servo is sticking but with the motor disconnected and the throttle up on my dx8 the cyclic sevos just go one side and stay there. The tail doesn't move. I wanted to try a reset but cant seem to get into the settings mode.
Have been following these instructions:
3-Axis Gyro Menu
To Enter Programming Mode
1. TX on
throttle set to high (100%)
2. Plug the flight battery into the
helicopter.
3. The Status LED will go solid blue, then there will be a
sequence of Red, Green, and Blue Flashing LED’s
4. The RED LED will now be
solid and the status LED will be flashing.
To change between axis use
the Elevator stick.
Red LED = Elevator
Green LED = Aileron
Blue
LED = Rudder
To change the gain value use the Aileron
stick
There are ten steps available in either direction, total of 20 gain
values for each axis.
The highest and lowest values are not high enough or
low enough to cause not to be flyable. It adjusts the gain in a window we
determined was useful to the consumer.
Right Aileron increases the gain,
the LED lights will start flashing faster.
Left Aileron decreases the gain,
the LED lights will start flashing slower.
When the Axis LED is solid
that is default value (neutral gain).
To reset the settings to
default
Hold right rudder for 5 seconds while in programming mode, there
will be a sequence of Red, Green and Blue flashing LED’s to signify the default
settings have been applied.
Rudder value must be at 100% travel for this to
occur.
To exit the menu.
Simply just unplug the battery. Set
the throttle to low throttle or throttle hold and re-plug in the battery.
Any suggestions?
I have an issue where the tail servo is sticking but with the motor disconnected and the throttle up on my dx8 the cyclic sevos just go one side and stay there. The tail doesn't move. I wanted to try a reset but cant seem to get into the settings mode.
Have been following these instructions:
3-Axis Gyro Menu
To Enter Programming Mode
1. TX on
throttle set to high (100%)
2. Plug the flight battery into the
helicopter.
3. The Status LED will go solid blue, then there will be a
sequence of Red, Green, and Blue Flashing LED’s
4. The RED LED will now be
solid and the status LED will be flashing.
To change between axis use
the Elevator stick.
Red LED = Elevator
Green LED = Aileron
Blue
LED = Rudder
To change the gain value use the Aileron
stick
There are ten steps available in either direction, total of 20 gain
values for each axis.
The highest and lowest values are not high enough or
low enough to cause not to be flyable. It adjusts the gain in a window we
determined was useful to the consumer.
Right Aileron increases the gain,
the LED lights will start flashing faster.
Left Aileron decreases the gain,
the LED lights will start flashing slower.
When the Axis LED is solid
that is default value (neutral gain).
To reset the settings to
default
Hold right rudder for 5 seconds while in programming mode, there
will be a sequence of Red, Green and Blue flashing LED’s to signify the default
settings have been applied.
Rudder value must be at 100% travel for this to
occur.
To exit the menu.
Simply just unplug the battery. Set
the throttle to low throttle or throttle hold and re-plug in the battery.
Any suggestions?
Comment