Cracking little Heli (that will teach me to think the worst)

[Flying_Amp]

After cancelling my pre-order, and keeping an eye on the reports from you guys, (i was determined to wait till v2) i took the plunge and bought one yesterday. I reckoned that a lot of the issues were probably down to either poor pre-flight checks, or the odd bad un!

After carrying out all the recommended checks, she flew! and i must say flys like a dream, HH are onto a winner here.

Coming down at 7.6v after 4 mins of flips loops etc in iU2 using Gens Ace 450mah.(16pks lol)

Tail i locked in, no problems at all with the A gear mesh or fouling the FET (did the paper trick) so after me being all doom and gloom, i am one happy owner.

Cheers

[liambaker996]

Hi I am hopefully picking one of these little beasts up this week could you advise on "the paper trick"
Thanks,
Liam

[Flying_Amp]

Just try and fit a thin piece of paper between the A gear and FET on the servo board, mine just pushes through with a little effort. some are supposed to be rubbing against the fet, but have not heard of it over here, just on the US sites