3-in-1 board issue?

[Moffy3968]

Was out flying at my local club night indoor meet which is in an equestrian barn. Spooled up my 130 into a hover, to which it started to drift to the right a little, then it banked hard right into the deck!
I've replaced the rhs servo but it keeps setting the servo to the bottom like shown in the picture. Also as well as this servo the one on the other side, both are very twitchy.
Is this an issue with the 3-in-1 control board?
I've also tried rebinding to DX6i to same result!

Help please!





Sent from my iPhone using Tapatalk

[Moffy3968]

I replaced it with a new servo, and the pic is the new servo after switch on it immediately bottomed out.


Sent from my iPad using Tapatalk

[Paz26181]

Try sub trimming, it could help and then clean servos

Blade 130X How to subtrim a bad mainboard that doesn't zero pitch/roll/yaw rates at center sticks - YouTube

[Moffy3968]

I emailed HorizonHobby and one of the technicians got back to me to check the monitor on the DX6i to establish is the sticks are centering, when I found it, there seems to be an issue with the aileron stick as wasn't centering and couldn't keep still twitching all over the place. So it's boxed up to go back for repair


Sent from my iPhone using Tapatalk

[Moffy3968]

Quick follow up, I received my tx back from HorizonHobby within the week! Great service by them, they replaced the right gimbal and recalibrated it FOC! When i turned it on and started up the 130x, it took off and hovered perfectly. Result!

[Mike Sanders]

I love it when a problem is solved. Well done.