Beam E4 FBL 6s setup questions.

[rotorWIZZ]

Hi Guys

Last week my new beam E4 advance with beam fbl head arrived.
Building it now togheter and there are some questions.
First my 6s setup;

Beam E4 advance FBL
Scorpion 2221-630
Kontronik Jazz 40A
Hitec 5065mg swash
Hitec 5084msg rudder
BeastX controller
EDGE fbl mainblades
KBDD tailblades
Völtz 6s 1300mah 35c

-With the FB setup the distance for installation of the linkage ball on the servoarms are 11-13mm.Cannot find a distance for a FBL setup?
-The angle between the mainshaft en the tailboom is not exactly 90 degrees,does anybody use the beastX controller and knows how to setup this thing properly.(I use it on my protos and trex 600 but the angles are exact 90 degrees so i can't find if its a problem for this heli by mounting it on the tailboom)

Greetz Rogiër

[Andy from Sandy]

I think you mean the 2221-1630 motor.

I have been reading about 6S conversions on the T-Rex 450 and they both share the same gear ratio. Those guys went with the 2221-1210 motor.

If you haven't purchased the speed controller yet then take a look at the Kontronik Koby. It is lower cost has a higher power output BEC and is firmware upgradeable by the end user using the prog disk.

[rotorWIZZ]

Yes i mean 1630...sorry
I bought the electronics allready and the engine is built in.
The setup is also tested in the beam by a friend of mine and it gave an awesome result.
Only thing he flied flybarred...