Jiberjaba help me please !!! :-)

[gasgasbones]

Jason, can you please do me a favour please ?

Ive just got the Beam Bound with the Spektrum and the AR6200

Can tell me what servos you have going into which channel, before I start faffing about with servo directions etc it would be nice to have a good starting point not sure what goes into the Aux ! ???

So looking from behind

Servo front left--channel ?
Servo front right--channel ?
Servo middle swash--channel ?

Esc into throttle
Gyro into Rudd
gain wire into gear ?

Any info regards to the setting too would be greatly appreciated :-) as you can tell im a relative noob so am just hovering about with some lazy eights etc. :-)

thank you Jason or any one else for that matter that chips in


Ltr pt8rs

Carl

[pjtyros]

Hi Mate, Here are my Beam settings:

From behind,
Front left Aileron
Front Right pitch into Aux
Rear servo Elevator
you are correct with the others

Swash mix =120 3 servo

Aileron + 60
Elev - 60
Pitch - 60

Reversing

CH1 norm
CH2 reverse
Ch3 Norm
Ch4 reverse 5,6 & 7 normal

Hope this helps

Paul

[unwind-protect]

What I do---this works on any radio
1) Set transmitter to 120 degree mixing.
2) plug servos into 1, 2,3 & 6
3) wiggle cyclic in a circle--- the three servos that move are your swashplate servos. Moving the throttle will make the remaining servo move (along with all the others).
4) wiggle cyclic left/right. Two swashplate servos will move; these are your lateral servos (sides of the swash).
5) Wiggle cyclic fore/aft. All swashplate servos will move; the remaining one of which is your longitudinal servo (front or back).
6) Install servos, and use servo reversing to get them moving correctly on collective inputs.
7) Use swash mix values to make servos move correctly on cyclic inputs.
HTH.

[gasgasbones]

Thank chaps thats a big help Im starting to get somewere i think.. however

Paul, are you on Dx6i and a ar6200 ? I dont quite understand how the channels relate to my tranny

on my reverse screen on the Dx6i i have

thro---- aile---
elev---rudd---
gyro--- pitc---,

What values N or R should these be at ?

Not sure how these work with the cyclic, when i get the throttle to move the three servos in the correct way they are then all over the gaff when moving left right back and forth !!! If i get them moving right for left and right back and forth then they are messed up when throttling up what a mare.

would i need to change the values for the Ail elev and pitch from + to -

Will keep playing about

Cheers again

Carl

[jiberjaber]

Hi Carl,

Looks like you got a load of good answers... here's what I had mine set to on the DX7 with 6200

THRO = NORM
AILE = REV
ELEV = NORM
RUDD = NORM
GEAR = NORM
PITCH = NORM
AUX2 = NORM

SWASH Mix I had
AILE = 70%
ELEV = 64%
PITCH = 67%

Viewing the heli from the nose in, I had Aile on left, Pitch on right and elevator on rear.

Hope that helps

[rspblake]

Cheers Guys for looking after Carl, Got a Text!

To say here is over the moon is a understatement!

Rob