My Trex 600EFL Pro Build Thread

[Reality Bites]

Ok, you will regret saying it was ok to bash your thread soon!..

Trying to fit my tail servo and I think the only way to get it to fit is by breaking off three of the four servo horn legs. On the other servos there is only one leg to the horn, on the tail, I only have the cross shaped horn. If I try and fit it the way it is, when the servo moves it will snag the frame!

[Rich23]

I had the same on the 450. I put one of the sats on the tail block and the servo horn was catching the antenna, I just cut them off and it still works fine.

Rich

[dani_r]

Ok, you will regret saying it was ok to bash your thread soon!..

Trying to fit my tail servo and I think the only way to get it to fit is by breaking off three of the four servo horn legs. On the other servos there is only one leg to the horn, on the tail, I only have the cross shaped horn. If I try and fit it the way it is, when the servo moves it will snag the frame!

Is this on a 600 Pro?

[Rich23]

Is this on a 600 Pro?

No on a 550

Rich

[johnsandywhite]

I am just in the process of building a 600EFL with AR7200BX. I notice you guys are using the outer holes on the swatch as it says in the manual to do. HOW are you getting the BLUE light at 6 degrees? I have WAY too much. Or are you just flying it as it comes?