T-Rex 600 DFC Head speeds for 3D flight?

[RcRotaryMadness]

Hi everyone,

Just curious to know what other people are running for head speed on 600 sized machines for 3D flight?

atm mines set to 2,400 which seems nice but like I say, just curious on what others are running and if it would be better going a little higher?

Cheers
Matt

[hedge]

Lol my nitro DFC is at iu1 2050, iu2 2150, I can only dream of 2400.

[rich-6]

I have mine at 1800, 2000 and 2250

I very rarely use 2000, 2250 is nice & gives me an easy 5:00 off 3600 packs. 1800 is good to pootle about and warm my thumbs up.

but I don't have the nice scorpion motor like you lol. Just a 600mx

[Sharpedge]

Just remember that the 600pro has been designed to run a high tail speed. It will 'pootle' about quite happily at lower headspeeds but don't push it as you will lose the tail.

[ChrisB]

Yes i hope the hinted new Align 600 electric comes with a proper tail ratio and can run 620s.

I run my DFC heads down at 1800rpm ish also,no issues.

[RcRotaryMadness]

Cheers guys, will probably stick to around 2,400 - bit unsure what the maximum is though. Should probably dig out the manual =/