v2 spinning wildly

[martnslater]

hi can anyone tell me what i am doing wrong
i have just built a 450 se v2 looks stunning
but i have mounted my gyro as stated .ok its only a imax g192 ,i knows its not a 401.
but its what came with the kit, but when i spool up and the head speed gets going it just spins out of control, is it a head speed isue or something else
and can someone tell me wich way the tail rotor blades go when you put left and right stick input thanks .
martyn

[heliward0]

gyro problem there mate try reversing the gyro (should be a switch on it )

[heliward0]

try this link mate it may help? http://video.helifreak.com/?subpath=...e=hdx_tail.wmv or http://www.helitown.com/VedeoInstruc...teTrex450.html there is some very usefull vidio info on this site,,,,

[pdcnc]

hi having very same problem with my g192 need a user manual

[Phil w]

Hi
Just buy a 401 sorted

[ChrisB]

Sounds like its sensing is reversed

Put the heli on the ground and extend the tail blades up/down

Put a left rudder command on the Tx stick and the leading edge of the lower blade should move to the right when looking from behind

If this is Ok then pick the heli up and twist it to the right and you should see the tail blades get the same input as the test,ie blade moves right which is a left rudder input to correct the right twist you gave it..

If this is wrong the heli will spin wildly and the gyro needs reversing,i am not sure how you do it with your one but its normally a switch or you physically turn it upside down and remount it

[helihead]

hi revers the gyro and try it but i have heard about gyros being fitted the wrong way before that is if it is possible with that gyro,,also set up make sure you have about 8" pitch pushing the tail left before you take off in normal mode.good luck hope you get it sortted before you brake it,,,