Trex 550/600 DFC Head question help

[Daanish]

Hi i am new to the dfc head, so i brought the head upgrade and then then i made it with all the links fully tightened but i am not getting the 0 degrees on the blades, i am using this on my 550.

[WildWake]

What model have you fitted it too????
If it's a 600n you need to shorten the main shaft and drill a new hole.

[snotvis]

I think you need to get a dfc mainshaft and shorten the links between the swash and the head.

[coolice]

Hey.

As you brought the DFC upgrade you will already have the DFC mainshaft, so what you need to do is shorten the plastic links slightly.
I have one fitted to my 550 and had to take 1mm off the back of the plastic link, allowing it to thread on further and give me 0 degrees pitch at the correct point.
.

[ROCKET RONNIE]

Hey.

As you brought the DFC upgrade you will already have the DFC mainshaft, so what you need to do is shorten the plastic links slightly.
I have one fitted to my 550 and had to take 1mm off the back of the plastic link, allowing it to thread on further and give me 0 degrees pitch at the correct point.
.

+1 here mate