trex 600 n le problems

[kescot]

hi there all
just wondering if any one could help me out a little or a lot

problem im having is a wobble with heli when its flying- looks all on the head, tail does not wobble at all, hopefully some one will know what im on about as im not sure how to explain it :P

head speed 2000-2200 which makes it do this at random times for no reason, but if u increase head speed so its at mental speed its stops. any one have any ideas be great full as im stuck.

i have replaced all the shafts / tt as well / dampner in head and main barings for the main shaft well all shafts i thou might make it do this,

any help would be greatfull

[GIXERMAN]

if you fitted black rubber you need a higher head speed until they bed in, if you wont to run a lower head speed fit the red dampers they are softer

[kescot]

ok i know thats sounds good as im kinda new to this hobbie, my 550e and black ones in and it flys fine. never though it would be them tbh. but i will try see how it goes.

cheers for the help gixerman

[GIXERMAN]

if your using a governor you could try dropping headspeed there might be a sweet spot for wobble, i have a Synergy n9 with inovation dampers and had to find the sweet spot

[vanman]

Are the blades in track and paddles as well if its fb

[kescot]

there was new blades as well put on the trex 600 and tracked as well as paddles.
no its not fbl
and there no gov on it atm as it was taken off to try narrow down a few things.
and to find the sweet spot the os 50 is reving it tits off hehe

[Sesame]

I've seen them wobble with too high and too low a headspeed but if your saying the engine is going crazy that could be your problem.




Sent from my iPad using Tapatalk HD

[kescot]

the head speed is in the area of 2000-2200 which sud be ok, this is when it wobble but if i increase the head speed to stop the wobble the engine is reving to high and i dont want to wreck a engine

[Raving Jim]

It shudnt wobble on the head at that head speed or even lower, either the blades are to tight or the dampers may be to hard at the head speed you are running.

[kescot]

checked the blades and they are not to tight either so just ordered new red dampers going to see if that helps if not it will be the bin and get a new one lol