Ccpm Interaction?

[nightstalker]

Hi guys i have just bought the spektrum module and AR9000 RX from my 9C SUPER, all is plugged in and iv reset all my ATVs and now im getting bad swash interaction, iv charged the RX batt so iv covered that end, running 5.8v bec system,

So do i still have to go through messing with ATVs to get this interaction cancelled out as i thought going to the spektrum module it would help with this as well as giving me the freedom to fly anytime, i dont want to get the CSM gizmo as iv spent to much money already but is there something iv missed here that could be the reason why im getting this??

P.S Im running 3x 9252s on swash on trex 600 nitro sport and have not been test flown yet but can be seen on bench

[robgt]

You will need to re-set up your heli - you have basically changed from Futaba to JR, and they are different with their centre and end point pulse-widths.

Cheers,
Rob

[Ade_Law]

if you get the mechanical setup right then you will not need to mess with the sub trims or end points at all.

if you do get ineraction at top/bottom and you cant get it any better mechancially then and only then you use 2 pitch to cyclic mixes.

im looking at getting a set of servos for the knight the 9252s are defo getting on a bit and its showing in the CCPM.

might get JR 8717 you can run them straight off of 2s lipo. I checked with tony at macgregors and the 900s JR rx will take it. so all i will need is a step down for the tail servo. I need to check up with curtis if the ATG will take it. I will need a step down for the throttle too.

Ade

[Arky]

i think i asked that question on the ATG and it was good for 8v but check Ade and let me know as i have forgoten

[ChrisB]

This running straight of a 2s Lipo is very appealing,i know the Spectrum Rx is happy with it but waiting for suitable servos,removing the regulator saves a smithering of weight and is an item capable of failing removed from the model,probably to be replaced by a switch that is just as likely to though

[Arky]

my switch would be a deans connector Chris