Anyone know where I can get charge lead to charge 6x4mm bananna connected batteries?

[NiceBlades]

As above, the single connection will also be 4mm bannana connectors. 12 awg wiring would be preferrable but not essential, will be used to charge 6x6s 3300mah lipo's at 1c. Can't find one anywhere, might have to buy ec5 version and cut the ends! Please Help, Ian.

[cjcj1949]

Not sure I fully understand. Won't you be using a balance board? Deans to 4mm can't be that difficult.

[NiceBlades]

Not sure I fully understand. Won't you be using a balance board? Deans to 4mm can't be that difficult.

Battery connectors are 4mm bannana, and 4mm bannana to the charger, so no deans. The only lead that comes close is this one IC-WEC5 : EC5 x6 Parallel Cable Silicone Wire at Midland: Midland Helicopters Ltd NewItems_NewItems

But instead of ec5's I need 4mm bannana connectors on all ends.

[mark_w]

IC-W232 : Bare Lead x6 Parallel Cable Silicone Wire

http://www.modelhelicopters.co.uk/cg...232#aIC_2dW232

and then add your own banana connectors

[NiceBlades]

Many thanks Mark, this will do nicely!

[cjcj1949]

Do you have a lead for the balance connectors?

[NiceBlades]

Do you have a lead for the balance connectors?

No not yet, I'm looking to get a cell pro pl8 with parallel boards, seems to be the most future proofed charger on the market and good value for the next 5+ years. I just sold my Schultz chameleon and 200 watt psu which lasted me the last 8 years. Cell pro boards are fused I believe also so safer than most. What lead were you going to recommend?

[cjcj1949]

The parallel boards have the sockets in them for both charge current and balancing. Using leads is another way to do it. I don't know if people who use leads bother with balancing.