700 elecrtonics installation

[Tim Procter]

To be fair Tim, this is an old photo of my 700. It is not flying at the mo, as changing over to a Futaba Rx, and also 2in1 is gone, as I now use LiFe packs direct to the Rx without a switch or Reg.

The cable tie on my 2in1 was very loose, and just there as insurance policy to cover the double sided tape behind, as there is not much area to stick to inside the electronics tray.

My 2in1 did do almost 100 flights as well, so I was lucky!

Fair play Rob.

Those Regs cost me 2x severe crashes at a high cost.

It won't happen again.

[Ceejay]

Here is the 3G installation on my 700N:

P1000682.jpg

P1000683.jpg

P1000684.jpg

P1000686.jpg

P1000687.jpg

I had to cut the support webbing on the radio tray to get the cables into the 3G controller without fouling. Hope that this helps.

[higgsy09]

thanks ceejay, pretty much where im going to put everything, how is the reciever aerial ? have you drilled a hole for it or bent it?

john

[Ceejay]

Hi John,

It is bent at the moment, following the body of the Rx.