new toy

[synergyn9]

I'm number 2 on the Revolution Models list, so no kit yet for me. They have only had one so far

Also got another on order from Andy @ Real Raptors but I suspect a bit further down the list there.

Can't wait to retire my 2 Raptor 50's which have performed admirably over the past 2 years but are now very sloppy and tired

Steve G - nice to see you on this site, u probably don't remember me (nick), but a couple of years ago, I came up to the Skem club and you helped set up the above raptors and talked me through my first couple of hovers. Was much appreciated at the time. Nice flights at Clubman by the way

[ChrisB]

Who agrees that the engine fitting removal should get an award for being over complicated

[Ade_Law]

Your joking! Engine and fan alignment needs no messing just bolt and fly. It doesnt get much easier.

[Fixxxer]

Or were you just hedging your bets Ade ?

[gazza]

Who agrees that the engine fitting removal should get an award for being over complicated

You sure you werent trying to squeeze it into your 600e Chris?

You cant be THAT impatient for the return of your dodgy Revo pack

[gazza]

Or were you just hedging your bets Ade ?

That information only Ade is 'Privet' to

[Hellski]

Must admit I'm with Ade on this one. Found it very easy, just loosen the carb to help while pushing through the bottom CF plate and bobs your uncle Just the electrics and set up now to do on mine,
just in time for when I'm away with the wife and kids will have to wait till the following weekend for the maiden flight, oh well at least there should be some parts available then

[Nutz]

and bobs your uncle

Thought he ran some heli business aswell as being an excellent pilot, wish he was my uncle

[Hellski]

I wish. I then wouldn't have to worry about spare parts and hiding receipts from the wife

[Ade_Law]

i pulled the main needle out and it slid right in. however you can wiggle it in without pulling the needle.

Ade

[ChrisB]

Well heres mine so far

[mattie-lodge]

Well that didn't take you long Chris

Looks well nice. Flying Saturday???????

Matt

[ChrisB]

Yep she will be ready Saturday

Got to make up all the linkages and do all the radio install and set up yet,,,phew

Leaving it for tonight now,,all went together rather well,,typical high quality as expected from Align

[Nutz]

Thats is the first red one I have seen, hopefully my one will be sent tomorrow ready for me to start my build on Saturday.

[richieclarkie]

Bet you can't wait to get her airbourne.

Been looking forward to hearing your opinion