Cyclic Servos for Trex600N

[Nutz]

I posted this yesterday but it seems to of disappeared.

Anyway, I cannot make my mind up between which servos to use on the cyclic of the Trex600N, I have narrowed it down to Futabas S9252, S9255 or S9351 (other suggestions welcomed)

I believe the S9351 are high power jobbies so I am wondering if I am going to run into any power problems running 3 of these on the cyclic, I plan to use a 4.8V 3700mAh Ni-Mh Sub-C to start with and then go to the new Align Lipo system when it comes out.

I have been recommended the Hitech 6965, but I am not the biggest fan of Hitech large servos and wish to stick to the Futabas.

[philiphenderson]

Any of those will work really well. Another option is the S9451 should you wish to run a higher voltage system without worries.

Phil.

[Nutz]

Forgot about the S9451, I got a couple of them in my old Kania K3 1/8th buggy I used to race.

I just need to get 1 more

Cheers Phil

[colin n]

One more

wonder where u could get one.???? been using them for a while, like them alot..

[Nutz]

I have just ordered 6, PM Philiphenderson, he may point you in the right direction.