Dx7 & align gov

[kev bell]

Hi people
does anybody know how to program a dx7 handset with an align gv govenor but keep the throttle cut on pmix two as shown by finless. All the post i have found use all three pmixes and the throttle kill on the trim.

Many thanks

[glen_j]

plug the gain for the governer into your aux 2 channel and set the end points for the headspeed you desire. no need to mess with the mixes

[Geek]

I use
Aux2 to aux2 mix
rate +15%
sw F-s2
offset 0

this give a good headspeed in normal and 15% more for idle up
have fun

[kev bell]

Hi
thanks for the help but maybe iam been a bit thick here so could you break it down to step by step for me

[raptormark]

try this http://www.bathmhc.co.uk/Training/Align%20RCE.pdf

[kev bell]

Thanks for the link, but it uses p mix which i would like to keep for throttle cut how do you do it without mixes

[raptormark]

give asid a mail he will tell u

[kev bell]

Hi
still cannot get the gov to work properley,

got the following settings,
aux2 to aux2
all prog mixes inh
thro curves set to default
travel adjust for aux2 +50 & -90
governor off when the aux2 switch is 0 and on at 1

these settings give me 1950 when the governor is on but when i drop the throttle below 30% it switches off? This happens in normal,idel up 1 & 2.

Help!!!!!!!!!!!!!!!!!!!!

[Geek]

Pm sent
sorry been out flying