3D flybar seesaw hole Q..

[Eckchaz]

As per the Align manual.. I've got both Align Heli's set up under the outside hole on the flybar seesaw for the SF mixing arm. As this is the recommended "stable" 3D flight. but it says that if I move it to the closer hole.. it provides a more "nimble" 3D flight?

How much difference does this make, do many of you use this hole instead?

[Grant_beltcp]

I find the "stable" hole far too slow and unresponsive. Chang it to the nimble setting. Much better

[Eckchaz]

I find the "stable" hole far too slow and unresponsive. Chang it to the nimble setting. Much better

Presumably it'll be quicker in 3D but will I be fighting to keep it in a decent hover or circuits/sports flying?

[Grant_beltcp]

No you shouldnt be - The 600 doesnt have insane flip rates when it's maxed out anyway. Give it a try, you can always add a little expo in if need be but i'm sure you'll like it.

[Eckchaz]

Thanks Grant_beltcp..

Would you suggest the same for the 500 or leave that bird till i'll more proficeint with my flying?

[Grant_beltcp]

I havnt flown many 500's, so its best off someone else answers that one for you i think....

[rapidgaz]

Thanks Grant_beltcp..

Would you suggest the same for the 500 or leave that bird till i'll more proficeint with my flying?

my 500 did not have the second hole, i had the esp kit. 700 has not got it eaither

[Eckchaz]

Just checked the 500... Yep, it's only got one hole... As if it's only the nimble hole. Just got to change the 600 then!

[chris jones2.4]

i went on the outside hole to the inside and i changed my horns so the balls were closer to gether and this was madness