My controller prob with Phoenix

[t4ttyt3ddy]

HI all

My CX2 controller isn't quite working properly,
After calibration the helis still drift to the right very badly any suggestions??

Thanks all

[kevinh]

is all your trims in the center before calbration

[t4ttyt3ddy]

Yeah it is, think it must be controller setup because it seems to have very little left turn!!!

[Boggy]

i have found that once the batteries are below 5.6v the calibration becomes eratic!!

[andylinney]

just me - could this be the ground effect in the sim? The Trex 500 needs a handful of cyclic in the hover...

Is it the same once the heli is up in the air? Equally change to a big 3D plank model and have a look at the ailerons to see if they're level.

Andy

[jboweruk]

i have found that once the batteries are below 5.6v the calibration becomes eratic!!

Yikes? I can't get 5.6V out of my batteries. What batteries are you using please?

[Boggy]

duracell plus

[t4ttyt3ddy]

I'll check my voltage I think it was below that, Thanks boggy, at the moment your like a CX2 god!!!!!

[jboweruk]

I'm using Duracell rechargeables, 2650 Mah, still only 5.3 volts though.