Phoenix Blade SR just not right

[tiddler]

Have just downloaded the Blade SR into Phoenix.
Now I don't know if things can go wrong during the download, but it just doesn't fly right at all
For one It is completely incapable of doing a back flip. Doesn't matter how much back elevator you put in, it just gets to about 45 degrees and stops
It does forward flips OK though

Anyone else got this problem with it ??

[seemore74]

Re: Phoenix Blade SR just not right

Why bother with the blade sr on phoenix mate?

Sent from my Xperia X10i

[bolders]

I dont beleive it is a download problem - it probably would just not work at all if this was the case.

I have just tried flying it and it is fine on mine. It does have a slight tendanc to level off if you put a bit of back elevator in though but this is only a small amount and nothing like what you are describing.

It may be a problem in your setup an initial check might be to see if you are getting +-10 degrees of pitch on the collective.

[tiddler]

I dont beleive it is a download problem - it probably would just not work at all if this was the case.

I have just tried flying it and it is fine on mine. It does have a slight tendanc to level off if you put a bit of back elevator in though but this is only a small amount and nothing like what you are describing.

It may be a problem in your setup an initial check might be to see if you are getting +-10 degrees of pitch on the collective.

Hi bolders
Well it beats me!! There's nowt wrong with my set up and all other models fly exactly as they should. Its not a collective problem either, that's fine and is set to + -10.
Its a cyclic problem but only when applying back elevator. Push in forward and its fine, the heli will roll forward nose down and continue to do so until you ease off. But when I pull in back elevator the heli starts to roll back (Nose up) but then gets to about 45 degrees and pretty much stops rolling. Definitely not right at all