phoenix

[mackem54]

any way you can setup phoenix for tail servo failure,
cheers

[g0pkh]

Not that I know of.
Perhaps they can add an option to use a 9254 servo

[BobJ]

Hi

You could use your radio to simulate this a bit, it's wouldn't be perfect but would help I am sure.
Either set up a mix on a switch to it gives you full rudder and at the same time link in the rudder duel rate so you have no control over the rudder, this would simulate a tail servo failure (which in real life are diffucult to get away with if the servo fails hard over if you have a driven tail)
Or just use the rudder dual rate again to remove all rudder control which would be closer to drive or linkage failure.
Not tried it but dropping the gyro gain to almost zero at the same time should help as well.

Cheers
Bob