Hover training possible bug

[Andy from Sandy]

I put Phoenix into hover training mode. I didn't change anything. It only allows for elevator only input and the caption shows pitch only.

After 3 to 4 minutes the model starts to go on a knife edge. Once the model has gone fully over the hovering resets.

If I select roll only then this time the model starts to tilt nose down.

[Birdie4x4]

Have you got the right model set on your TX, also try reseting the TX in phoenix.

[Grant85]

Funny you should say that as when I was on an online session last night the model I was flying would keep tilting over when I was practicing some nose in hovering, I would give full aileron stick but to no affect.I thought it was just due to the system being slow as there were so many people online or either that it was just my flying LOL!