Setup with Futaba T7CAP (FF7)

[jiberjaber]

So I have spent most of the night messing around with this setup. I haev been flying around for a while now in airplane mode on my TX because I wanted to fly straight out of the box!

So finaly got round to trying to set up the TX with phoenix as a proper heli TX.

What a PIA!...

I have managed to set it in both HN3 and HR3 modes (120 deg swash) but when I dial out the CCPM in the mix settings on pheonix, I can't:

a. get it all dialled out, it is still there (but only a little);
b. get full travel on the roll and pitch when I do get it dialled out as much as I can!

If I go to recalibrate the TX to try and get full travel on the roll and pitch chnls 1 & 2 it zeros all the mixing out of the CCPM..... as you might guess this is getting just a little fustrating!

Am I missing something basic here? I also notice my bar's on the chnl values never are smooth, they jump around a fair bit between states (if you know what I mean).

It would be nice if there were some markers on the bar of the chnl selected in the mix edit so you can judge centre etc.... I might suggest that to them

Any ideas?

Thanks in advance

[Ade_Law]

The ccpm de-mix in phoenix is for those transmitters for some dodgy micros that ONLY transmit in that mode.

create a new model memory, set the model type to H-1 clear the mixing in phoenix and recalibrate.

Ade

[jiberjaber]

Thanks Ade, knew it would be something simple