Tweet
When I calibrate my Tx in Phoenix, it doesnt recognise the throttle hold switch. Do I have to change something on the TX?
-
x 3 -
Throttle Hold is purely a function on the Tx, you will probably find that it is disabled (INH in futaba settings) and I suspect would be on most if not all other Tx's. You need to enable Throttle Hold and set the throttle position that you want it to hold at - i.e. idle - say 5%ish
Once its enabled you will see the TH switch drop the throttle to the pre-set level.
Hope this helps
RobRob
T-Rex 450 Pro - BeastX v3 FBL, Hitec 5065's, DS520, Futaba R6203SB
Quad x-copter - KK 5.5 Multicopter v4.7, 850KVA motors, 30A ESC's, Orange RC FASST Rx, Carbon & Alu frame, LED strips for orientation, 10x4.5 props.
Quad x-copter - KK Plus 5.5d, 1000KVA motors, 30A ESC's, Orange RC FASST Rx, GF & Alu frame, LED strips, 10x4.5 props (coming soon!)
Futaba 9CP & 10CG
-
I had somebody set all that up for me and when I plugged into Phoenix it recognised it straight away, so as Dedcalm said, it has to be set up in your TX first...
Comment
-
What you could do is select a new model and set it to heli 1 servo in your dx7. (I think)
Then just select dx7 in phoenix and calibrate accordingly. It should work in the default setting.Comment
Comment