got an anoying problem!

[TomBCR]

went to use the sim after about a month without being used! went to calibrate the tx to the sim as the trims were all over the place and when i did the throttel stick only reconises after half throttle, and then its either flat out or nothing! making flying almost impossible tried both my dx7 and my twister gold tx and both are the same!

has anyone else had this problem or anyone point me in the right direction of what could be wrong!

havnt been into rc flying for long and nothing seems to be going my way at the mo!

cheers guys!

[TomBCR]

anyone??

[daren]

just got in from work and had a brain wave while sat on the bog!
Is your throttle trim in the middle? If yes move it to the bottom

[Flying Elvis]

Try not re-centring the throttle stick after you've rotated it round to it fullest extent. As the action of re-centring messes up the calibration.

[andylinney]

Just a thought but...

Check your curves on the DX7, make sure that the throttle is linear. Equally make sure you're not in throttle hold or idle up on the twister tranny.

[phockzie]

Plug the dongle in and remove the drivers in device manager for it. then unplug it and plug it back in, windows will re-install the drivers automagically.

[TomBCR]

Plug the dongle in and remove the drivers in device manager for it. then unplug it and plug it back in, windows will re-install the drivers automagically.

i wish i could! when i plug the dongle into the usb port nothing comes up in the device manager so i cant uninstall the drivers. does anyone know what the drivers are called because then i can try and find them manualy then uninstall them that way. so when i plug the dongle in again the drivers will then be installed automaticly!

[phockzie]

it'll probably be under "Human Interface Devices" or "sound, video and game controllers" in device manager.

Expand these catagories, and unplug & reinsert the device a few times, one of the devices in these catagories should disappear / re-appear.