Lead weight on the front...gyro settings?

[Guest]

I am flying in Phoenix and since setting it up with the same settings as Boggys for the Blade 400, as you climb and pull down on the elevator the heli turns on rudder 180 degrees. It is making it quite tricky and it comes back down pretty quick.
Do I have an incorrect setting somewhere?

Thanks
Jack

[Guest]

Bump...btw my Gyro Sens on the DX for Phoenix is 73%.

[Boggy]

run through a full advanced calibration. the gyro gain in the tx is not used its set in phoenix. also in the edit model section under tail rotor check it has heading hold set and not rate.( this is what your describing sounds lke to me. try flying sideways if it turns trying to fly forwards your in rate )

[Guest]

Cheers Ron, will let you know

[Guest]

Sorted, it was in rate mode.

I must have made the change by accident but if I delete the copies of the models it makes when you make a change the default one has rate mode enabled. I am not sure if this is right. Also rotor governor is enabled.
In the 3D version, the tail is set to HH.