phoenix shutting down

[car-killer]

set up a flying session last night and get upto 4 flyers and the sim shuts down..i get a message saying "phoenix.axe.file" has stopped working...this happened half a dozen times any ideas

[Unsung Hero]

Thats all i ever get so interested to see what replies are given. Think its exe i get lol .

[Mojogoes]

I was also on and the same thing happened to me .......plus if anymore than 2 people are on it just starts getting sooo glitchy its not worth flying at all......or is that just me and the lack of power of my lop-top/graphics card , only last week i put in 2 512mb memory boards instead on 1 256mb which has helped some.

[car-killer]

so listen up phoenix we want a fix not more models...that'll do the trick

[moyesboy]

Since installing the last models and the flying site with the update I did last night phoenix shut down on me reguarly with a measage saying it had an unexpected prob and did I want to inform m$crosoft. It never did that before.

I could see the online sessions but could not join.

I tried to mimic my 600n's slightly rearward c of g. for some strange reason moving the c of g of the model has almost no noticable effect on the way it flies, unless it is within 2 feet of the ground when it tips over. It really is wierd. I gradually put the c of g back to 10cm and near the ground it behaves exactly how that might really be (almost uncontrollable) but once at altitude it will happily slam up and down, hover upright and inverted, perform stationary rolls with hardly any elevator correction. Then as you land you need suddenytl need half the cyclic stick to stay level!

[Toolman]

That new Apache is nice though!

Have you contacted PhoenixRC, if you have a repeatable crash I think they can tell you which files to email them to diagnose it.

Tim.

[car-killer]

the apache is nice and flys real easy..and i will send file details
thanks for that

[car-killer]

flying right now

MOSCOW R/C CLUB

MY NAME FLASH

[Mojogoes]

Since installing the last models and the flying site with the update I did last night phoenix shut down on me reguarly with a measage saying it had an unexpected prob and did I want to inform m. It never did that before.

I could see the online sessions but could not join.

I tried to mimic my 600n's slightly rearward c of g. for some strange reason moving the c of g of the model has almost no noticable effect on the way it flies, unless it is within 2 feet of the ground when it tips over. It really is wierd. I gradually put the c of g back to 10cm and near the ground it behaves exactly how that might really be (almost uncontrollable) but once at altitude it will happily slam up and down, hover upright and inverted, perform stationary rolls with hardly any elevator correction. Then as you land you need suddenytl need half the cyclic stick to stay level!

I've had much of the same and when joining a session last night i had to put in nearly full left cyclic as it would just pile into the ground........as i flew around and then landed it to take off level i had to dial in some right cyclic time and time again until it was about a couple of left cyclics off of centre.......but the glitching is the worst thing it really pi$$3s me off......it just can't haddle more than one or two people flying at one time.........its in need of a lot more memory/power.