DX6i Setup

[t4ttyt3ddy]

Hi all

Have a DX6i that I am yet to try out with either Phoenix or my CX2 (Been Busy Decorating).
Hoping maybe to get some practice in this week, so wondered do you guys have a seperate model for each of the models on phoenix or do you just have one phoenix model?

Would you use the same model on Phoenix as you would on your actual Heli??

One last thing does anyone know where I can get Tx settings for various helis from have got one for CX2, would like others!!

Cheers

Thank you!

[Aidi]

Although its all reletively new to me, I choose to create a new model on the Tx for the simulator. The reason behind this is so i can experiment with different settings without any disruption to the settings which actually work on the model. Then, when you are happy you fully understand what you have changed on the sim model, you can them implement them into the actual flying model.

Rgds
Aidi

[t4ttyt3ddy]

Then, when you are happy you fully understand what you have changed on the sim model, you can them implement them into the actual flying model.

I was thinking that to be honest, Only have a CX2 at the Moment any ideas where I could find Tx settings for other models like the Blade400 or the T-Rex 450.

Or is it just a case of playing and seeing what happens because I'm still at a loss at to what all the flick switches do!!!

[Ade_Law]

i use a model memory for phoenix, set it to heli mode with single servo swash type (not CCPM) enable throttle hold and set idle up to 100, 50, 100.

Fly the planes and the sim CX2 in normal mode.

set a seperate model memory for the CX2 probably easiest to set the tx to airplane mode for this and check that the reverses are correct.

Ade

[jboweruk]

Heli mode works fine once you know how to set her up. At first I'd go with use Acro mode till you know what you're doing.