Tweet
AccuRC sim Futaba S-Bus adapter cable problem,
I haven't used AccuRC that much since I got it, mainly due to time.
Anyway it’s been updated a lot since I last used it & so I decided to set it up using my 8FG transmitter, using a spare S-Bus RX.
I have had the correct adapter lead for some time but not had RX spare till now.
Updated to V1.5 of AccuRC fine, programs runs ok but I couldn't connect my TX to the RX.
The key thing was the RX light wasn't coming on, No power going to it.
I managed to find a thread on HF about this, there are some incorrectly wired leads out there!
See thread here, sbus rec no power - HeliFreak
Once I had swapped the red & white wires round, all is well.
I am just posting this, so if anyone else searches for this problem they will find the answer.
Tim.
I haven't used AccuRC that much since I got it, mainly due to time.
Anyway it’s been updated a lot since I last used it & so I decided to set it up using my 8FG transmitter, using a spare S-Bus RX.
I have had the correct adapter lead for some time but not had RX spare till now.
Updated to V1.5 of AccuRC fine, programs runs ok but I couldn't connect my TX to the RX.
The key thing was the RX light wasn't coming on, No power going to it.
I managed to find a thread on HF about this, there are some incorrectly wired leads out there!
See thread here, sbus rec no power - HeliFreak
Once I had swapped the red & white wires round, all is well.
I am just posting this, so if anyone else searches for this problem they will find the answer.
Tim.