Lighting

[Adrian]

Looking for a place that would sell some bright red strobe lights for fitting into a MD500E fuze (600) size and any relavent batt set up ect, now ive just put the mechs into the shell
500e 003.jpg

[waveydavey]

Hobby king do loads of different ones and I've seen them on ebay too

[Mslater]

Rs components, every kind of led and light you can imagine

[HGJL2009]

used this on my Hughes 500 from GiantShark also fro HK but only global shop

Night Flying Lights

[Zeeflyboy]

I highly recommend the DElight controller...

It's fully programmable via USB and can run all your lights, making a couple of channels run beacons with whatever flash interval you want is as simple as setting it up in the software.

By the way if you fancy some scale skid lights I made some for my project, I assume probably the same skid size (I/D just under 10mm) - they can be ordered from shapeways here, but the postage might be prohibitive for such a small item on it's own. They are designed to take square 5mm high flux LEDs.

MD500 Skid Lights for 5mm High flux LED by Zeeflyboy on Shapeways

[SamS]

Can't help you there mate, but can't wait to film this next time you're out here !

[the-borg]

Hi Adrian this is the place I get my LED's from http://www.rclighting.net/rc_lighting_12_028.html it plugs into the RX the control board is very small and lite idea for small helis.
You go to http://www.rcheliaddict.co.uk/videos...0-airwolf.html you can see the LED's on my airwolf.

[Adrian]

just orderd the 500 set ,now all i have to do is...take it all out again

do these lights have to be stuck in?

[the-borg]

Hi Adrian I do with just a blob a of cyno.

[Adrian]

Well there here but for £22 it dont look much! Hope they look good when fitted

[the-borg]

Hi Adrian I agree there is not a lot to the unit but I think when you fit the Led's your 500 will look the bizz.