Seahawk 600

[muscleflex]

That's very nice dude

[Ruston]

Seahawk 600

Looks really nice. Do you have any photos of the angled gearbox? I am just about to commence a very similar build on a 800 size Huey using the TF Models fuselage and Trex 600 mechanics. It would've interesting to see how you did yours.

[shades]

Looks really nice. Do you have any photos of the angled gearbox? I am just about to commence a very similar build on a 800 size Huey using the TF Models fuselage and Trex 600 mechanics. It would've interesting to see how you did yours.

First there is a dropper gear box to give the boom a lower angle to get it down the tail section.
DSCF1717.jpg DSCF1976.jpg
The main boom and riser boom were cut to length and torque tubes made to suit.
DSCF1965.jpg
Here you can see the pivot system to get the tail control rod up the riser boom.
DSCF1957.jpg
Then at the top of the back end I used a standard tail case, but assembled 180 degrees around so that I could get to the locking bar and fixings. Normally this is on the left hand side for a standard tail fin so needed to be switched.

[Made2Fade]

Seahawk 600

Awsome that buddy im impressed :-)