bell 47g-11 scaling

[raptor-flyer]

HAS ANYONE ATTEMPTED TO CORRECTLY SCALE A CENTURY BELL 47g-11,I AM LOOKING TO DO THIS BUT WHERE TO PUT SERVOS SO THAT SEAT ETC CAN FIT IN IS MY PROBLEM,TOYED WITH ONE OR TWO IDEAS BUT MEANS CUTTING PARTS OF FRAMING{NOT TO GREAT }.
ANY HELP,PICS IDEAS( OTHER THAN SCRAP IT AND GET SOME OTHER PIECE OF C***.)
I WORKED ON THE SOUIX HELI IN THE ARMY AIR CORP AND WOULD LIKE TO MAKE THIS THE SAME.

[robgt]

Caps lock key...
All caps is very hard to read.

I'm not sure which heli you're talking about here.
There are Bell 47G II scale kits out there, do you already have one?
If so, which kit do you have?
Cheers,
Rob

[raptor-flyer]

50 Sized Century .Still original yellow

[robgt]

My Uncle has the same heli...
The servos on his are mounted high up behind the seat area. As far as I recall, they are out of the way up there?
No photos for you sadly.
Is your servo layout different somehow?
Cheers,
Rob

[lawbreaker]

Hi, try this link, some ideas on a conversion if the link works

http://www.homanns.com/handihomann/h...47g_custom.htm

[raptor-flyer]

Problem is, seats ought to be right at rear of cabin but servo cradle/holder comes mid way into this area,looked at putting two below seat/tail then in rear of frame other needs some sort of linkage changes.

[raptor-flyer]

Thanks very much Lawbreaker,just the right lines to get me going along. Will start altering hopefully tomorrow.Again Thanks