Beast x setup with new servos ?

[jjjjdup]

I have just installed three new Savox SH 0257 MG servos on the swash on my 300x.
all my movemenst seem to be reversed from before with the eflite servos?
I have reversed the channels in the tx and it is OK now but the gyro correction is the wrong way around.
The swash tilts in the same direction I tilt the heli !? And does not couteract the cyclic movement.
how do I correct this.
I have set up point G- Swash centre and got the swash nice and lavel now.

[MarkG_R1]

Beast x setup with new servos ?

Step I is where you should set up the reverses for the servos

And step M for the compensate

[jjjjdup]

Thanks.
Yes there it is in the manual.
I should have just carry on reading.
Thanks again!

[PaulJC]

Yeah they need reversing in the BX as opposed to the transmitter, also make sure that the pulse width is set correctly to the new servo's it'd be a shame to burn them up due to incorrect settings

[GIXERMAN]

Just keep reading the manual, they are a bit daunting to start but will soon make sense.

[jjjjdup]

Things are starting to make sence now.
is it my imagination of are all yhe modes the same normal, sport, pro, extreme, tx.
all looks the same to me.
in tx mode. My DR doeas not seem to make any difference.
when swash moves with tx input it seems very slugish.
whal can i do to make it more snappy
thanks

[rasman2k]

Regarding modes - You won't see a difference on the bench, but you will in the air. I personally found I needed to use transmitter mode to get the flight characteristics I was looking for

[parksy]

Servos will seem sluggish compared to stick movement because you are not in direct control like you were before fitting the bx, the bx now interprets stick movement and computes accordingly, as above you will not notice once in flight.